RalliTEK Rear Lift Kit Spacers - All Impreza 2002-2007 / Forester 1998-2008 / Legacy 1995-1999
With your choice between 1/2" and 1" lift options, these HDPE (High density polyethylene) spacers install right over your strut hat. Great for adding more lift to a vehicle's original/aftermarket equipment or helping level out your fender gap.
New strut mount hardware included! Class 12.9 bolts and class 8 to 10 nuts.
In comparison to aluminum spacers, our HDPE material is light weight and not prone to additional NVH (Noise, Vibration, and Harshness) unlike typical aluminum spacers which transfers straight to the chassis.
HDPE or high density polyurethane has a compression yield strength of 20Mpa or 2900 pounds per square inch.
RalliTEK does not recommend using more than a 1" lift (3+ spacers) in total on the same strut hat/mount.
When threading the new RalliTEK supplied hardware through the rear spacer, it may be a little tight. This is done on purpose so the job can be done alone (without the hardware falling out the bottom of the spacer). It should thread in a little bit on its own by hand, but only on the tapered side. Find that side and get it started. You can then use a pair of pliers to twist the hardware the rest of the way using leverage.
No customer comments for the moment.