Gauge Pods

Replace the trim in your car with gauge pods in order to install gauges inside your car.

Gauge Pods

Replace the trim in your car with gauge pods in order to install gauges inside your car.

Showing 1 - 20 of 27 items
  • NOTE: This product supersedes 30-4350


    The Tru-BoostX Boost Controller Gauge delivers all of the features you loved about the original only now with AEMnet for data logging and a big, fat internal MAP sensor that can handle boost pressures up to 80 PSI of boost.


    The Tru-BoostX Boost Controller gauge delivers digital accuracy but with the simplicity of a manual boost controller. All AEM Tru-Boost gauge programming is done using the faceplate buttons and no laptop is required. AEM’s specially designed Boost Control Solenoid and all necessary hardware is included.


    Program Two Boost Levels + Scramble Boost Setting – Program two boost modes for different levels of performance (up to 80PSIg internal MAP sensor), and program a time-based scramble boost setting that is controlled using a switched input. You can also turn off the controller and use the gauge as a display.


    Change Wastegate Open Pressure—Ideal for reducing boost spikes and improving spool up.


    Display Boost Levels in PSIg (PSI), BAR, or kPa (PAS) –See your boost in the units you prefer, and scale the 24 outer LEDs to match your peak boost levels for the perfect sweeping motion.


    Set Alarms and Display Peak Boost—Set the 24 green outer LEDs to flash-based on boost pressure so you are alerted to an over-boost condition. A ground output is included for triggering an optional LED warning light. Select the “B” button to see the peak boost level and clear the value using the menu.


    Overboost Protection Built-In—Protects your engine from an over-boost condition by shutting the boost control solenoid off until it is reactivated by you through the buttons on the faceplate.


    Integrated Error Protection—Alerts you to a fault if the boost control solenoid is shorted or disconnected so you are never left guessing whether the Tru-BoostX is operational.


    Datalog using AEMnet CAN bus—Outputting channels over AEMnet provides so much more than just boost pressure! Send 13 channels of data over a 2-wire connection, including boost pressure, peak boost, boost target, boost scramble duty, over-boost status, wastegate crack pressure, boost control solenoid status, and more.

    FEATURES:

    • Tru-BoostX Gauge Features:
    • A boost display gauge and boost controller in one! 
    • Easy to program – no laptop required 
    • Boost control solenoid and all necessary hardware included 
    • On-board 80PSIg MAP sensor—no upgrade kit needed for high boost vehicles
    • Two boost level settings and scramble boost setting
    • Wastegate open pressure setting for controlling boost spikes and faster spool
    • Display boost levels in PSI, BAR or kPa
    • Overboost protection and programmable alarms, ground output for an optional LED warning light
    • Peak boost level recall
    • X-Series design for the best visibility (87% larger center LED and 33% larger face design)
    • X-Series dimensions make it easier to install (0.825” overall depth, 0.20” cup depth)
    • AEMnet CAN-bus enabled for data logging (13 channels of data over the 2-wire connection)
    • Standard 52mm (2-1/16”) cup
    • 24 programmable green outer LEDs
    • Auto-dimming sensor for ideal brightness day or night
    • Positive locking connectors 
    • Optional silver bezel with white faceplate accessory kit (30-0352-ACC)

    Subaru
  • SMY Clustermaker has been designed to provide users with another option to safely mount the Cobb AccessPort AP3. 

    Saab
    Subaru
  • This insert is for you guys that only have 1 gauge in your SMY ClusterMaker Pod. This insert matches the color and texture of the pod to create a seamless look in your car.

    SOLD INDIVIDUALLY

    Saab
    Subaru
  • The ATI ePod Steering column gauge pod is a great way to display your gauges without cluttering up your dash board. Similar color as the factory dash and does not require any drilling or modification for fitment. Gauge cups rotate for easy adjustment and to set them exactly where they need to be.

    Don't forget to choose a gauge size.

    Subaru
  • ATI introduces their dual 52mm gauge pod cluster bezel for the WRX / STI. This is a direct fit replacement for the factory cluster bezel and comes pre-textured to blend into the factory dash. With its sleek design, this gauge cluster bezel will blend in with your interior for that factory look. Bezel comes in unpainted black finish.

    Subaru
  • The ATI eZ Pod for the BRZ/FR-S is a great solution for mounting gauges. The Triple Meter Pod is a direct replacement for the passenger side dash trim piece on any/all of the aforementioned models, and as such, requires almost minimal install time and expertise. The Triple Meter Pod was designed to accommodate three standard 60mm gauges of the drivers' choice all of which are angled conveniently toward driver - or three, standard 52mm gauges with ATI's conversion pieces. The BRZ-FR-S Triple Meter Pod is made of Injection Molded ABS Plastic and will be available in two finishes; a sprayed flat finish, and a softer, felt-like finish.

    Scion
    Subaru
  • With an ever increasing challenge in integrating gauges into well designed interiors, the vPod essentially keeps the interior unaltered by integrating gauges in the ventilation system. They blend in seamlessly.

    Features:

    • Each vent design is specific to a vehicle 
    • Pod insert for OEM vent housing 
    • Precision injection molded plastic for precise and consistent production 
    • Color and texture matched 
    • Angled design towards driver provides best possible viewing angle 
    • High impact ABS plastic 
    • Quality fit and finish

     

    Scion
    Subaru
  • The ATI Faceplate is meant to fit into the ATI Subaru WRX / STI Center Gauge Pod. Has 4 snaps on back to allow faceplate to snap into pod without customization or modification. Available in Blue, Carbon Fiber Look, or Chrome.

    Subaru
  • These rings allows ATI ePods to convert 60mm gauges cups to handle 52mm gauges.

    Mitsubishi
    Nissan
    Saab
    Scion
    Subaru
  • The ATI eZ Pod for the BRZ/FR-S is a great solution for mounting gauges. The Triple Meter Pod is a direct replacement for the passenger side dash trim piece on any/all of the aforementioned models, and as such, requires almost minimal install time and expertise. The Triple Meter Pod was designed to accommodate three standard 60mm gauges of the drivers' choice all of which are angled conveniently toward driver - or three, standard 52mm gauges with ATI's conversion pieces. The BRZ-FR-S Triple Meter Pod is made of Injection Molded ABS Plastic and will be available in two finishes; a sprayed flat finish, and a softer, felt-like finish.

    Scion
    Subaru
  • The ATI Faceplate is meant to fit into the ATI Subaru WRX / STI Center Gauge Pod. Has 4 snaps on back to allow faceplate to snap into pod without customization or modification. Available in Blue, Carbon Fiber Look, or Chrome.

    Subaru
  • The ATI gauge pod will hold either 52mm or 60mm gauges. The pod comes pre-textured and colored to match the factory dash color. No painting is required. Out of the box it will hold 60mm gauges. All that is required for it to hold 52mm gauges is to use step down rings.

    Gauges with longer bodies may need to use the supplied 10mm ring spacers for proper fitment.

    This pod attaches directly to the stock clock pod using supplied double sided tape and screws and is intended for LHD vehicles only.

    Subaru
  • These rings allows ATI ePods to convert 60mm gauges cups to handle 52mm gauges.

    Mitsubishi
    Nissan
    Saab
    Scion
    Subaru
  • The ATI gauge pod will hold either 52mm or 60mm gauges. The pod comes colored to match the factory dash color. No painting is required. Out of the box, it will hold 52mm gauges. All that is required for it to hold 60mm gauges is to remove a perforated ring. 

    Mfgr. Warranty:1 year
    Attachment Method:OEM Replacement
    Gauge Size (mm):52mm and 60mm
    Material:Plastic
    Pod Color:Black

    Subaru
  • The Autometer A-Pillar pod holds three 2 1/16" gauges. The pod fits over the factory a-pillar. Includes push snaps to install and lock in place. Comes cast in gloss black, surface is able to be painted. This gauge pod Does not fit WRX Wagon. Sedan Only.

     

    Mfgr. Warranty:1 year
    Attachment Method:Hardware
    Gauge Size (mm):52mm
    Material:Plastic
    Pod Color:Black


    Subaru
  • The Autometer Center Gauge Pod holds three 2 1/16" gauges. Fits into the area where the factory clock is. It is cast in black, so you will need to paint to match the factory dash color.

    Attachment Method:OEM Replacement
    Gauge Size (mm):52mm
    Material:Plastic
    Pod Color:Black

    Subaru
  • The Autometer A-Pillar pod holds two 2 1/16" gauges. The pod fits over the factory a-pillar. Includes push snaps to install and lock in place. Comes cast in gloss black, surface is able to be painted. This gauge pod Does not fit WRX Wagon. Sedan Only.

    Attachment Method:Hardware
    Gauge Size (mm):52mm
    Material:Plastic
    Pod Color:Black

    Subaru
  • This SMY ClusterMaker Gauge Pod is a dual 52mm gauge setup that replaces the factory cluster bezel. Made with injection molded ABS plastic it is stronger than the OEM piece it replaces but it matches it perfectly in terms of the texture you can see. It looks so good you would think Subaru themselves made it. 

    Each pod comes with rubber bands specially sized to fit your gauges nice and tight in the pods. 

    This is unconfirmed to fit RHD cars.

    Subaru
  • This SMY ClusterMaker Gauge Pod is a dual 52mm gauge setup that replaces the factory cluster bezel. Made with injection molded ABS plastic it is stronger than the OEM piece it replaces but it matches it perfectly in terms of the texture you can see. It looks so good you would think Subaru themselves made it.

    Each pod comes with rubber bands specially sized to fit your gauges nice and tight in the pods.

    Subaru
Showing 1 - 20 of 27 items