With your choice between 1/2" and 1" lift options, these handy spacers install right over your strut hat. Great for adding just a little bit more height to vehicle's original/aftermarket equipment or helping level out your fender gap.
New strut bolts included!
Our body lift spacers are made of acrylic. The compression yield strength of acrylic is 95Mpa or 13,778 pounds per square inch. By comparison HDPE or high density polyethylene has a compression yield strength of 20Mpa or 2900 pounds per square inch.
RalliTEK does not recommend using more than a 1" lift (3+ spacers) in total on the same strut hat/mount.
When threading the new RalliTEK supplied hardware through the rear spacer, it may be a little tight. This is done so on purpose so the job can be done alone (without the hardware falling out the bottom of the spacer). It should thread in a little bit on its own by hand, but only on the tapered side. Find that side and get it started. You can then use a pair of pliers to twist the hardware the rest of the way using leverage.
2015-2016 WRX & STI: Camber after installation is was -1 to -2 degrees. Still within stock parameters to readjust.
No customer comments for the moment.
only logged users can upload product photos click here to login